Distance between phases of 35kV busbar

For a 35kV busbar, the typical phase-to-phase spacing is approximately 150–200 mm, depending on insulation type, pollution degree, and installation conditions.

IEC Guidelines and Practical Considerations

The IE

C 61439-1 standard provides minimum clearances for busbars based on voltage, insulation, and environmental factors. For medium-voltage systems like 35kV, the phase-to-phase spacing is influenced by: Voltage level: Higher voltages require larger clearances to prevent arcing. Pollution degree: In environments with dust, moisture, or industrial contaminants, spacing must be increased.

Insulation type: Bare busbars require larger air gaps, while insulated or epoxy-coated busbars can use smaller spacing. Altitude: At elevations above 2000 meters, air density decreases, reducing dielectric strength; spacing should be increased accordingly.

Typical Values

For 35kV busbars in metal-enclosed switchgear: Phase-to-phase spacing: 150–200 mm (6–8 inches) is commonly used in practice to ensure safety and compliance with IEC standards. Phase-to-ground spacing: Usually similar to phase-to-phase spacing, especially in ungrounded or impedance-grounded systems. These values are practical guidelines; manufacturers may adjust spacing based on dielectric testing, busbar current rating, and mechanical support requirements.

Bare busbars may require slightly larger gaps to prevent flashover, while insulated busbars can be closer together.

Additional Design Considerations

Thermal expansion: Busbars expand with temperature; spacing must account for this to avoid reduced gaps. Mechanical support: Proper supports prevent sagging or vibration that could reduce spacing. Creepage distance: The distance along insulating surfaces must also meet IEC requirements to prevent surface tracking.

In summary, for a 35kV busbar, a phase-to-phase spacing of 150–200 mm is standard, but the exact value should be confirmed based on insulation type, environmental conditions, and manufacturer specifications to ensure safety and compliance with IEC standards.